Supernova E3/Schmidt SON tail light bracket - Seat stay mount for left and right side
Left side of bike = SN-FS-LS-SST
Right side of bike = SN-FS-RS-SST
****** Please note that the SST brackets now have a rougher finish - they almost look galvanized. The shiny finish was too hard to consistently obtain and was a serious bottleneck in our production.******
It has come to our attention that there is a new Supernova tail light that does not use the 50mm bolt spacing. If you have a Supernova tail light, make sure that your spacing is 50mm before ordering.
While our tail light brackets were designed specifically for the contours of the Supernova E3 tail light, the 50mm hole spacing is an EU standard and works for a wide variety of lights, including many Busch & Müller tail lights and the Schmidt SON tail light for racks. Measure your light and if it has 50mm bolt spacing, it will likely work!
Thanks to Bob at Bantam Bicycle Works for the idea for this addition to our light bracket line. It is now, by far, the best seller of our light brackets.
As shown in the image gallery, this bracket is intended to be mounted to a boss on the seat stay. The light bolt holes and the attachment hole are all M5. Made from highly weather resistant 5052 aluminum.
This bracket is now available for both the left and right side of the bike. If you travel on the right side of the road, mounting the light on the left side of your bike is typically best. Get the right side bracket if you travel on the left side of the road. Or you can maximize your lighting potential by running both sides for dual rear lights. Rear LED lights draw such little power that most generator systems can handle running two rear lights with no problem. Symmetry and safety FTW!
If you are a bike shop or frame builder with a business license and insurance, please contact us for information on wholesale prices for bulk purchases.
9g - Weight is based on a representative sample. Actual weight may vary slightly.
Made in Portland, Oregon, USA.